Chapter 14: Risk allocation and insurance
| Library | The Application of Contracts in Developing Offshore Oil and Gas Projects |
| Pages | 164-192 |
| Author | Philip Loots,Donald Charrett |
When reviewing an oil and gas construction contract for the first time, one’s impression might be that there is a much stronger emphasis on allocation of risk and liability than in other forms of construction contract, by way of indemnities which give effect to the ‘knock for knock’ regime discussed below.
Projects are growing in size and complexity worldwide. Significant time and cost overruns do not reflect corresponding increases in profitability for contractors and have a significant impact on the feasibility of projects. The most appropriate choice of contracting strategy is a key to a successful project outcome, but the Contract itself and other legal remedies are limited in what they alone can achieve.
A clear and cohesive risk regime which identifies and assesses the key risks associated with the development of an offshore oil and gas project and implements a variety of risk management strategies to address those risks is an essential component of a successfully executed project. It is important to recognise that these key risks are generally different from those found in conventional onshore construction, although all risk identification starts with the specific project itself.
There is a widely-held view that standard forms of contract generally reflect a consensus between Owners and Contractors as to a fair and reasonable and fault-based allocation of risks and should therefore be used as a reference point when considering risk allocation in practice. Refusal by the Owner to negotiate certain terms and conditions is often claimed by Contractors and suppliers to be an unreasonable exercise by the Owner of its strong bargaining position, without any attempt by the Contractor to find a rational explanation for such behaviour, and without seeking a proper understanding of the needs of the oil and gas sector. There appears to be little pre-bid communication between Owner and Contractor as to the Owner’s legal policy, risk allocation, indemnities and insurance and the need for uniformity in contract administration on large projects, which are all factors which lie behind the tendency to use bespoke (and some standard) terms and conditions of contract.
A better understanding of each party’s position at the outset might lead to negotiating on the merits, and better bargaining outcomes, improved relationships and better commercial relationships between Owners and Contractors, rather than the Contractor taking the position from the outset that it has been coerced into accepting an unfair allocation of risk, being inadequately prepared for that position and opening its war-chest of claims from ‘day one’.
Many oil and gas projects are financed by a consortium of companies, owing to the scale and cost of such projects. The consortium typically executes a Joint Operating Agreement (JOA) to govern their contractual responsibilities. A knowledge of how the JOA distributes risk is necessary when drafting the construction and services contracts. Usually an Operator is appointed who is responsible for the exploration, development and production in the oil and gas project. The respective rights and liabilities of the Operator and the project participants are provided for in the JOA. The Operator may be appointed as an agent or an independent contractor of the project participants under the terms of the JOA. The character of the appointment is important, as it influences the liability of the Operator. If appointed as an agent, the Operator potentially owes obligations to the project participants, and the project participants are liable under the Contract according to their participating interest under the JOA. However, most Operators avoid agency and the resulting fiduciary obligations so as to limit their exposure to liability.
Under the AIPN JOA 2012, the Owner is not expressly appointed as agent on behalf of the JV parties. Most JOAs provide that the Operator is under a duty to conduct all operations in a ‘diligent, safe and efficient manner in accordance with such good and prudent petroleum industry practices as are generally followed by the international petroleum industry under similar circumstances’.
The usual starting position for Operator liability is that the Operator is not liable to the project participants for any loss, and project participants indemnify the Operator against losses incurred by the Operator in performance of its duties under the JOA. In most cases, non-Operator parties then negotiate a number of carve-outs to the liability regime, which may include: where a loss is incurred as a result of the Operator’s gross negligence or wilful misconduct; where the Operator commits unauthorised, negligent or unlawful acts; liability caps; or liability for consequential loss. If the Operator is contracting as a principal, then liability rests with the Operator and the upstream participants cannot be sued or sue on the Contract. In most cases, an Operator will structure a third-party contract such that any liability under the Contract can be passed to each of the project participants in accordance with their participating interest share under the JOA.
Patrick Mead’s study of major construction contracts found a variety of problematic risk issues: risks were not allocated to the party best able to manage the risk due to the preference for bespoke forms of contract for many major projects; formal risk assessments were not being undertaken; risk clauses varied from those in standard contracts; risks were transferred to consultants and contractors which were impossible for them to manage; risks were not costed in tenders; cost savings would have occurred had risks been more effectively allocated; the implications of changing risk allocation were not known; and disputes and claims increased as a consequence of changes to risk allocation. 1
Risk is ‘the uncertainty of a result, happening, or loss; the chance of injury, damage or loss; esp., the existence and extent of the possibility of harm’. 2 In the discovery and exploitation of an oil or gas resource, a minor act or omission can potentially result in severe consequences for all involved, including injury, death, pollution and significant financial losses. It is an environment of high risk.
Risk may be allocated using a combination of each of the following methods to allocate liability between the parties:
-
Exclusion of liability clauses, which prevent a party from being liable to another party if a particular risk materialises.
-
Limitation of liability clauses, which limit a party’s liability if a particular risk materialises.
-
Indemnity clauses, which require one party to indemnify the other party against the consequences of a particular risk if it materialises.
Indemnity clauses are used to support contractually allocated liabilities; enforcement of an indemnity is often preferred to relying on an action for breach of contract or breach of statutory duty. This is because the principles relating to assessment of damages for breach of contract such as causation, remoteness of damages and mitigation need not be established when relying upon an indemnity. Unless expressly stated, the indemnified party is not obliged to mitigate its own loss and there will be no indemnity cover for a loss caused by the indemnified parties’ negligence. Indemnities are usually limited to ‘serious loss’ and are often identified by minimum threshold amounts in the Contract. The terms gross negligence and wilful misconduct, and consequential loss need to be very carefully defined.
It is important to recognise that the risk appetite and business objectives of each participant will differ and that decisions on the optimal risk allocation and management of an oil and gas project should be taken on a case-by-case basis with regard to the particulars of the project and the objectives of the participants. Owners and their advisors spend a lot of time and money on preparing risk reviews from which draft terms and conditions are prepared. Curiously, tenderers are then invited to submit tenders which usually deviate from these terms and conditions in material respects, leading in some cases to numerous qualifications (bid clarifications) of varying degrees of importance resulting in a final risk allocation which may be far removed from what was initially intended. Sometimes only the Owner knows from the outset what is, and what is not negotiable, but this is not communicated to tenderers. Because contractors are not made aware of what is, and what is not negotiable, lengthy and expensive tender negotiations include lengthy fruitless discussions on many issues which should simply not be open for discussion at all.
A party can manage the risks it identifies by:
-
allocating the risk to another party
-
insuring against the risk or
-
accepting the risk and ensuring that it is adequately managed.
Get this document and AI-powered insights with a free trial of vLex and Vincent AI
Get Started for FreeStart Your Free Trial of vLex and Vincent AI, Your Precision-Engineered Legal Assistant
-
Access comprehensive legal content with no limitations across vLex's unparalleled global legal database
-
Build stronger arguments with verified citations and CERT citator that tracks case history and precedential strength
-
Transform your legal research from hours to minutes with Vincent AI's intelligent search and analysis capabilities
-
Elevate your practice by focusing your expertise where it matters most while Vincent handles the heavy lifting
Start Your Free Trial of vLex and Vincent AI, Your Precision-Engineered Legal Assistant
-
Access comprehensive legal content with no limitations across vLex's unparalleled global legal database
-
Build stronger arguments with verified citations and CERT citator that tracks case history and precedential strength
-
Transform your legal research from hours to minutes with Vincent AI's intelligent search and analysis capabilities
-
Elevate your practice by focusing your expertise where it matters most while Vincent handles the heavy lifting
Start Your Free Trial of vLex and Vincent AI, Your Precision-Engineered Legal Assistant
-
Access comprehensive legal content with no limitations across vLex's unparalleled global legal database
-
Build stronger arguments with verified citations and CERT citator that tracks case history and precedential strength
-
Transform your legal research from hours to minutes with Vincent AI's intelligent search and analysis capabilities
-
Elevate your practice by focusing your expertise where it matters most while Vincent handles the heavy lifting
Start Your Free Trial of vLex and Vincent AI, Your Precision-Engineered Legal Assistant
-
Access comprehensive legal content with no limitations across vLex's unparalleled global legal database
-
Build stronger arguments with verified citations and CERT citator that tracks case history and precedential strength
-
Transform your legal research from hours to minutes with Vincent AI's intelligent search and analysis capabilities
-
Elevate your practice by focusing your expertise where it matters most while Vincent handles the heavy lifting
Start Your Free Trial of vLex and Vincent AI, Your Precision-Engineered Legal Assistant
-
Access comprehensive legal content with no limitations across vLex's unparalleled global legal database
-
Build stronger arguments with verified citations and CERT citator that tracks case history and precedential strength
-
Transform your legal research from hours to minutes with Vincent AI's intelligent search and analysis capabilities
-
Elevate your practice by focusing your expertise where it matters most while Vincent handles the heavy lifting